Arduino Bluetooth RC Car: Part 4

Step 4: Software Since I purchased an Arduino clone (mistake), it has a different USB chip - one which is not supported natively on Mac OS X El Capitan as of now. I, not knowing this, went through a great deal of trouble figuring how to upload the Blink sketch before figuring this out. Look at the bottom … Continue reading Arduino Bluetooth RC Car: Part 4

Advertisements

Arduino Bluetooth RC Car: Part 3

Step 3: Wiring The first step is to plug in all 3 GND's of the H-Bridge's breakout to the Arduino's GND (you may want to try the power rails). The power rails are extremely hard to use. Inserting the wire sideways sometimes helps. Next, solder the red wires to the top motor terminal of each motor … Continue reading Arduino Bluetooth RC Car: Part 3